Wall foundation
Use the Wall foundation tool to place continuous strip foundations under structural walls.
When you select Wall foundation, a tool palette opens.
Main tools
- Define – create a new wall foundation element
- Properties – check or edit the parameters of an existing wall foundation. Opens the Default settings dialogue for the selected wall foundations
- Convert – convert existing horizontal beam and some compatible solid shape elements into wall foundations
- Physical alignment – adjust how the foundation is aligned vertically in the model
- Default settings – set default parameters for geometry, material and alignment (read below in more detail)
note
To read more about the Physical alignment, see the topic:
User interface ➔ Tab menus ➔ Structure ➔ Additional dialogues ➔ Physical alignment
Line definition methods
Available when the Define tool is selected.
- Straight line – define the foundation with a straight segment between two points
- Arc by center, start point and angle – define an arc using its center point, the start point of the arc, and the angle
- Arc by 3 points – define an arc by selecting three points lying on the arc curve
- Arc by start, end point and tangent – define an arc using its start and end point and the tangent direction at the start
- Line by selection – select an existing line or edge to define the foundation path
Default settings dialogue
When you press the Default settings button, a dialogue window opens.
This dialogue contains five tabs: General, Section, Material, Stiffness, and End conditions. These tabs use the same settings as regular bar elements such as beams or columns.
note
To read more about these settings, see the relevant topics below:
- For General tab see:
User interface ➔ Tab menus ➔ Structure ➔ Additional dialogues ➔ Foundation General - For Section tab see:
User interface ➔ Tab menus ➔ Structure ➔ Additional dialogues ➔ Bar Section - For Material tab see:
User interface ➔ Tab menus ➔ Structure ➔ Additional dialogues ➔ Regular Material - For Stiffness tab see:
User interface ➔ Tab menus ➔ Structure ➔ Additional dialogues ➔ Bar Stiffness - For End conditions tab see:
User interface ➔ Tab menus ➔ Structure ➔ Additional dialogues ➔ Bar End Conditions